DFW Rusty
Well-known member
- Joined
- May 21, 2020
- Member Number
- 898
- Messages
- 395
My measurement was inside of flange to end of splines.
I get the cutting to length, and I figured that is the same way I'll do it. Slide em in, measure how far they stick out, cut that amount off... easy peasy...
I guess I could try to slide the tape into the housing and see if I can get a measurement from inside the carrier to the outside of the mounting face of the axle housing and see if I can get by with a little longer shaft.
I get the cutting to length, and I figured that is the same way I'll do it. Slide em in, measure how far they stick out, cut that amount off... easy peasy...
I guess I could try to slide the tape into the housing and see if I can get a measurement from inside the carrier to the outside of the mounting face of the axle housing and see if I can get by with a little longer shaft.