YotaAtieToo
Thick skull
Well you are far enough along to sit in it with a beer(s) and make motor noises. Looking good!
This stage usually last between 8 and 80 months
Well you are far enough along to sit in it with a beer(s) and make motor noises. Looking good!
Well you are far enough along to sit in it with a beer(s) and make motor noises. Looking good!
This stage usually last between 8 and 80 months
Are you going to flex your rear tire into that pokey thing?
Looking good Erik
Speed holes on something that small wouldn't be worth the wear on my tooling
that bump mount needs more support. it will twist the tube at the very least, more than likely rip it out off.
Right, but it's still only mounted to one tube. Probably 1 3/4x120?ya the hole saws where not happy doing the 1/2" i made the mount out of but oh well
the bump mounts are boxed and will be welded on all 4 sides of the can and the chassis tube.
There's got to be a back road somewhere up there.It's 2x.120 dom but I get what you are saying and will have to take a look at it. I haven't fully welded them so could add to it still.
Pretty sure the boarders are still closed so won't be making it. Was hopping to come down for the spring nimac rock race but that probably won't happen as well.
It's 2x.120 dom but I get what you are saying and will have to take a look at it. I haven't fully welded them so could add to it still.
Pretty sure the boarders are still closed so won't be making it. Was hopping to come down for the spring nimac rock race but that probably won't happen as well.
There's got to be a back road somewhere up there.
What's the Canadian version of a coyote?
Can you run a vertical tube on the top of the box, as close to the can as possible, up to the tubes above?