Take something like a scraper and dig around the base of the recess to taper it larger at the bottom. Then use an epoxy like JB Weld or similar to glue the magnet in. That will give you a mechanical bond to the acetyl which isn't adhesive friendly.hot glue. not very well, but I also put a strip of tape along the backside so if it picks up metal shavings they aren't stuck to the magnet itself.
The magnets I used had holes for screws, which I planned on using instead of glue. BUT since I had no way to cut the recess easily without a center-tip on the bit (spade bit), there's no meat to screw into at the center of the hole. They won't get much use, I'm hoping the hot glue/tape holds them enough.
They're just gonna un bolt your pintle or install theirs below yours or angle grinder cut the lock.Trailer lock
Locks don't stop thieves anywayThey're just gonna un bolt your pintle or install theirs below yours or angle grinder cut the lock.
Unless you're trying to prevent employees from using the trailer outside company time I don't see that doing much.
for the amount of use they'll see, I think the shitty hot glue/tape solution should work OK. Really I made these so i'm less likely to nick the vise itself with a grinder. Inspired by randomly seeing them on Amazon for $10-20 and realizing I had a piece of scrap and some magnets sitting around. 45 minutes last night instead of watching TV and I had them done. Perk of the "temporary" retention is I can re-use the magnets in a new set if I ruin theseTake something like a scraper and dig around the base of the recess to taper it larger at the bottom. Then use an epoxy like JB Weld or similar to glue the magnet in. That will give you a mechanical bond to the acetyl which isn't adhesive friendly.
niceTrailer lock
nice
I like the serpentine pulley
prolly be a lot more secure with one of them enclosed shackle puck locks, but w/e
Will be getting puck lock, just using the lock we already haveThey're just gonna un bolt your pintle or install theirs below yours or angle grinder cut the lock.
Unless you're trying to prevent employees from using the trailer outside company time I don't see that doing much.
The stairs?How are the fucken deer supposed to get in that thing?
Aren't you pussies supposed stand around in trees?The stairs?
Me? Naw, I don't hunt out of trees. I hunt proper...out of the truck window. Kapow!Aren't you pussies supposed stand around in trees?
That thing has no satellite TV? No 12v coffee maker?
Material support and squaring arm for the shear. Long overdue project. I've still got to bolt on the edge, and scribe some measurement marks on the squaring arm.
No but I rigged up this grate and toasted some pop tarts and heated up some pizza for lunchAren't you pussies supposed stand around in trees?
That thing has no satellite TV? No 12v coffee maker?
Nobody makes a 6" rise hitch with a 1" hole and 1-1/4 shank.
Well, nobody but me.
Yes, that's a 2-5/16 ball on it.
Ok. Im guessing to move trailers around the yard with a four wheeler?Nobody makes a 6" rise hitch with a 1" hole and 1-1/4 shank.
Well, nobody but me.
Yes, that's a 2-5/16 ball on it.
you don't live in MAThere's a reason nobody makes that....
20k gooseneck behind the subaruOk. Im guessing to move trailers around the yard with a four wheeler?
We don't hunt. We harvest.....😁Aren't you pussies supposed stand around in trees?
That thing has no satellite TV? No 12v coffee maker?
Probably a mini van.Ok. Im guessing to move trailers around the yard with a four wheeler?