Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
I’m gonna get some quotes from the water jet guys this week to see what the swivel bases would cost to get cut out buy them. The flame cut ones are ok. Not nice enough for what your vises look like.
I almost got through my list just a few more to make parts for and then I’ll make up some swivels and possibly some nod plates also.
I love you, too.I’m gonna get some quotes from the water jet guys this week to see what the swivel bases would cost to get cut out buy them. The flame cut ones are ok. Not nice enough for what your vises look like
I almost got through my list just a few more to make parts for and then I’ll make up some swivels and possibly some nod plates also.
Yeah that’s a plasma cutter. I’m not too sure on them guys yet. Still needs a lot of learning to be done before they get good at it .
WTF is a nod plate?I’m gonna get some quotes from the water jet guys this week to see what the swivel bases would cost to get cut out buy them. The flame cut ones are ok. Not nice enough for what your vises look like
I almost got through my list just a few more to make parts for and then I’ll make up some swivels and possibly some nod plates also.
..![[486]](https://data.irate4x4.com/avatars/m/0/94.jpg?1700178133){kind=avatar}
Fkn ANIMAL look at those scored up waysHere’s a video for @[486] to show the lack of chatter. I’m surprised this worked. Got 13 tubes out of that stone and she still has meat left for a few more
I was going slow on the one in the video. I sped it up by 25-30% on the next ones. Was hard to hold phone and feed at the same time.Fkn ANIMAL look at those scored up ways
I'm surprised at how fast you can feed it in there. Easy to forget how quick a nice coarse and open abrasive will cut.
btw when you do the tapered keeper key, don't hammer it in there too hard before cutting the ends off
morse taper's real easy to get a tool shank in there way too deep cause of how shallow a taper it is
. 
they can still get to the point where you end up needing to beat on both sides of the spindle in a synchronized manner with a couple hammers before the wedge will move the drillThe spindle has both a keeper slot and a slot for a drift wedge to get it back out. Not too worried about getting it stuck in there.
Panzer is a rock star.
Must be close to 25-30. I’m running out of boxes for the tubes
need to order another batch. There are about 6 or so names left on my list. Should be getting those sent out soon. 
I even have a spare now.
Spares are always good to have. I'm pretty hard on vises so can't complain about my current one breaking.
Working well so far but I should make a tilt base for it one day. Tilting might be more important for me since my base can be rotated.
Damn BRAVO that is kick ass.One of the guys has a little Eastwood powder coating machine. Never used one before but it was pretty cool. I got a pound of powder for about 20 bucks, and didn't even use half only bummer is it was supposed to be metal flake and it's more like glitter, hard to see unless it's in the sun. All in all it looks nice, and it's gonna get beat up anyways.
One of the guys has a little Eastwood powder coating machine. Never used one before but it was pretty cool. I got a pound of powder for about 20 bucks, and didn't even use half only bummer is it was supposed to be metal flake and it's more like glitter, hard to see unless it's in the sun. All in all it looks nice, and it's gonna get beat up anyways.
. Let’s hope it doesn’t 