Front axle is a 2005 F250 Super Duty Dana 60 with open diff, 3.73 gears. I was going to build a 4 link for this, so I have removed all of the factory brackets. There is still some grinding left to finish cleaning it up. It is disassembled to inspect and make handling easier, but complete except brakes. $900
9" is a Diamond Axle builder housing, meaning it is meant to be cut down to your desired width. It is long enough to be made a front axle either driver or passenger drop, and can also be a rear axle. It fits standard and HP 9 inch 3rd members, but also the bigger trophy truck 10 inch 3rds. Tubes are 3.5" x 3/8" DOM. No 3rd member or gears included. Comes with large fill/inspection port that can be installed wherever you prefer. $800 - SOLD
The 9" was going to be a rear axle for me, so I made some housing ends for it, aka unit bearing cups. They accept the same unit bearing hubs as the F250 front axle. These I would consider "factory blems" as there were some issues from the plasma table that didn't get removed during machining. They are still perfectly functional, just not perfect looking. They are bore to be a nice snug "tap on with a dead blow hammer" fit to the 9" housing. $100 for the pair - SOLD
I also have 2 brand new F250 unit bearing hubs that fit the above mentioned cups and also the front Dana 60 axle. Paid 300 plus tax and shipping. $200 - SOLD
Located in Camarillo, California. Can not ship at this time.
9" is a Diamond Axle builder housing, meaning it is meant to be cut down to your desired width. It is long enough to be made a front axle either driver or passenger drop, and can also be a rear axle. It fits standard and HP 9 inch 3rd members, but also the bigger trophy truck 10 inch 3rds. Tubes are 3.5" x 3/8" DOM. No 3rd member or gears included. Comes with large fill/inspection port that can be installed wherever you prefer. $800 - SOLD
The 9" was going to be a rear axle for me, so I made some housing ends for it, aka unit bearing cups. They accept the same unit bearing hubs as the F250 front axle. These I would consider "factory blems" as there were some issues from the plasma table that didn't get removed during machining. They are still perfectly functional, just not perfect looking. They are bore to be a nice snug "tap on with a dead blow hammer" fit to the 9" housing. $100 for the pair - SOLD
I also have 2 brand new F250 unit bearing hubs that fit the above mentioned cups and also the front Dana 60 axle. Paid 300 plus tax and shipping. $200 - SOLD
Located in Camarillo, California. Can not ship at this time.
Last edited: