Crawl Away
SyrupSucker Land Refugee
I am looking for recommendations for a lift. I was considering the Clayton Overland. Any experience with that kit? This is for my daily driver, so the emphasis would be on ride quality.
Lift Options
- Thread starter Crawl Away
- Start date
-
- Tags
- jeep
Metalcloak if your looking for ride quality.
72blazer
Marion Cobretti
I’m running a 2” Mopar Lift. Runs great on the road. JeepGeneration guy wheels hard with this same lift. So I think I’ll be good. If money isn’t a factor, I’d go MetalCloak as well. 
Beat95yj
Rolling 24/7
Synergy is legit. They Have two jl’s that they have beat to hell and they drive beautiful.
Will Scarlet
The universe is vast...
- Joined
- May 20, 2020
- Member Number
- 766
- Messages
- 1,724
Although I don't have a JL, I have installed the Clayton Off Road Overland kit on my JK. I daily drive and have no issues. And I figure the kit for the JL would be the same.
Hope this helps... 😉
Hope this helps... 😉
Crawl Away
SyrupSucker Land Refugee
- Thread starter
- #6
I’m running a 2” Mopar Lift. Runs great on the road. JeepGeneration guy wheels hard with this same lift. So I think I’ll be good. If money isn’t a factor, I’d go MetalCloak as well.
Thanks. Money is always a factor.
Crawl Away
SyrupSucker Land Refugee
- Thread starter
- #7
Thanks. I will check them out.
thedirtman
Well-known member
Synergy is not going to be any cheaper than Metal Cloak but make nice stuff. I prefer the Metal Cloak joints over the synergy as the are a bit softer and flex easier, less stress on the mounts. Metal Cloak is not an expensive kit, not sure why everyone says they are pricey. When you compare apples to apples they are typically cheaper and offer more flexibility in set up vs most others out there.