4 link

All parts are new, everything is located in Yokuts Valley, CA 93675 Organizing in the garage and realizing I don’t need these parts. 2x14 coilovers with piggyback resi and compression adjusters. $1000/pair - 2 pairs 2” bump stops, 2” stroke with threaded body. $500/pair - 2 pairs...

Is there any MAJOR benefit to the motobilt 4 link kit over doing it the old fashioned way? The only obvious I see is the built in skidplate. Looking for opinions.

I don’t see a thread on this searching but I suck at that I guess. So, I plan on doing a 4 link suspension on my samurai front and rear using Dana 44 front and 9” rear differentials. I know the springs need to be narrow or skinny from what I see out there. What is out there that works really...

How do you find the angle of triangulation? Like the angle of my triangulated upper links?

I have a Clayton 4 link setup the lower links drag on everything. I want to move the lower frame links up on the outside of the frame I just haven’t seen it done. Is this an issue

I am building a mid engine rwd pile mainly for the street. But I would like to play in the sand dunes with it also. Leaf sprung solid rear and what will be a triangulated solid front. After a lot of playing around I have good numbers for the street at high speeds which will also be good in the...

There is some great tech on here on 4 links. I have a 4 link question that is diffrent so I hoping guys with way more experence then me with triangulated setups can give some advise. I have a mid engine 2wd pile with a 81" wb using rear leafs and currently a IFS front. I am cutting out the...

so decided to design it all in fusion this morning because i didnt wanna measure by hand i think everything came out good? lower links will be adjustable from 8 degrees or10 degrees thats the 2 different screen shots building it into a cralwer have a set of 12in kings that were speced for the...

Recently discovered some frame rot above the drivers side rear spring hanger that has caused some issues with the leaves and has got the whole back end of the truck tweaked a few inches (DS wheel base = 103" and PS wheel base = 107"). I figured it's as good a time as any to just link the rear...

Looks like its time we need this, I was hoping it would take a bit longer, but I guess its a sign that builds are being done. So, for those asking about how their suspension numbers check out, throw it here. Preferably in the form of a screenshot of the calculator. Just trying to keep the bible...

Figured that with the talk of threads dedicated to specific tech topics, might as well get the ball rolling early. THIS IS FOR SOLID AXLES ONLY, NOT INDEPENDENT SUSPENSIONS. I will do my best to gather as much of this info below as possible. It should be noted that this is a collection of info...

Current Version: 6.10 All versions I have access to can be found on the Resources Page. Link to the linked suspension bible: December's Bible Build: Linked Suspensions Link to the Check My Numbers thread: How's my numbers? With the changes to the board, a goal was set of generating more...

About a year ago, I convinced my wife that we needed a jeep in our life again. Hunted around and found this beauty: 1988 YJ GM LQ9 700r4 Tranny Atlas II 4.3:1 D60 Front 14B rear ARBs 37s lots of holes everywhere Sketchy wiring etc. The original goal was to some somehow stretch the wheelbase...