What's new

MCI 102-C3 coach to RV - General/Floorplan

In the planning stage of how I'd like to mount the Verona wheel hub to the closets. I think I'll be mounting the WMS to the closet disc because it has more surface area to offer more support under the disc. Probably going to knock the pilot down on the lathe and turn either the ID or OD of the pilot to a diameter that I can match on my circle cutting jig for a nicely centered register.

I'm debating on what to do with the wheel studs, if anything. I noticed that the flange bolt circle looked about the same as the wheel stud bolt circle. Smacked a stud out and sure enough they match. Too easy. I can grab a bolt at ace to grind a centered point on and thread it into the flange to pass through a wheel stud hole to make an indention of where to drill for bolt holes to match the wheel stud pattern.

20210328_015949[1].jpg
 
Drew that Samsung fridge into the floor plan. The kitchen/den area plan isn't close to done yet. We may rearrange the front of the floor plan a bit.

bus floorplan.png
 
You need this fan motor? It's likely not that good of shape but it has a speed sensor and I can get you the specs

1000013633.jpg
 
I can't even remember now what you were doing for fan...

Now that a lot of our heavy equipment has gone brushless electric fan that might be a new solution for yah.
 
I can't even remember now what you were doing for fan...

Now that a lot of our heavy equipment has gone brushless electric fan that might be a new solution for yah.

I'm surprised they went electric from hydraulic. Seems like an easy failure point vs a hydraulic motor
 
I can't even remember now what you were doing for fan...

Now that a lot of our heavy equipment has gone brushless electric fan that might be a new solution for yah.
I still have the heavy brushed motors and Dart PWM controllers for it. At the time that I was putting that together, I couldn't find any reasonably priced brushless stuff. Right now, I'm starting to collect some brushless RC stuff to try out for various projects. Might snag some brushless bike stuff as well.
 
I still have the heavy brushed motors and Dart PWM controllers for it. At the time that I was putting that together, I couldn't find any reasonably priced brushless stuff. Right now, I'm starting to collect some brushless RC stuff to try out for various projects. Might snag some brushless bike stuff as well.
There is a lot of choices these days.
I paid $85 for a 850w 19" fan off eBay
I'm sure e-bike motors would make great motors if the cooling is addressed.
 
Top Back Refresh