is there an equation for that?It's a triangle, so a bit of trig. Figure out one side and double it to get the angle between them.
What exactly are you trying to do? If you just want the angle for shits and grins get an angle finder and put it between both uppers. If you don't want to do that, you can vaguely approximate the angle with:is there an equation for it?
Im just trying to make sure i have enough angle in my upper links. By distance between chassis pivots / upper link length, do you mean how far my links are from each other on the frame rails/link length, or the distance from my frame mount to alxe mount/ the length of the link.What exactly are you trying to do? If you just want the angle for shits and grins get an angle finder and put it between both uppers. If you don't want to do that, you can vaguely approximate the angle with:
asin( distance between chassis pivots / upper link length )
This calculator will throw out a degrees value:
Arcsin(x) Calculator | Inverse sine calculator
Online arcsin(x) calculator. Inverse sine calculator. Enter the sine value, select degrees (°) or radians (rad) and press the = button.www.rapidtables.com
I would recommend using the inverse tangent.is there an equation for that?
Also what is ¨convergence angle¨'on your 4 link calculator?
Thank you.
Is that’s in the calculator? I don’t see that.I would recommend using the inverse tangent.
It is the value you are looking for.
Is that’s in the calculator? I don’t see that.
Nah bro you just cut grind weld and grind(a lot more)then realize it isn't going to work then sell it off for dirt cheap to one of us who can use the parts for something elseSounds like OP needs to put down the welding helmet and do alot more reading on the subject to get an understanding of these things....
So the total angle from convergence angle would be how much triangulation is in the upper and lower links?
Im trying to lean right nowSounds like OP needs to put down the welding helmet and do alot more reading on the subject to get an understanding of these things....