TTMotorsports
Red Skull Member
OK so I currently sell my Tacoma LT Kit's with an option for Toyota Solid Axle Spindles and then you can use those hubs OR IFS hubs. Now up to this point I have machined down the OD of the Toyota wheel hubs to run 1st gen Tacoma rotors and calipers. Now my question is does anyone know of a brake rotor that will slip over the factory Toyota 4x4 hubs that is the correct roughly 7/8" thickness for this? I install new wheel bearings that don't press through the rotor to hold that on already.
Thanks.
Thanks.