AdrianD
Well-known member
- Joined
- May 26, 2021
- Member Number
- 3967
- Messages
- 114
Hi everyone!
I need to make this handrail for the staircase: vertical and top bars are 25/32" x 1 3/16" (20x30mm for the metric crowd) and the support is on the stairs is 5/32" plate.
Do you have any tips for welding this, like weld sequencing?
I plan to bolt the support plate to the stairs and then tack into place all vertical bars, align them, tack the top bar, take it all off and do the full welds laying flat on the floor.
Sadly I don't have a welding table but I do have a mitre saw and my trusty mig.
I need to make this handrail for the staircase: vertical and top bars are 25/32" x 1 3/16" (20x30mm for the metric crowd) and the support is on the stairs is 5/32" plate.
Do you have any tips for welding this, like weld sequencing?
I plan to bolt the support plate to the stairs and then tack into place all vertical bars, align them, tack the top bar, take it all off and do the full welds laying flat on the floor.
Sadly I don't have a welding table but I do have a mitre saw and my trusty mig.