Snoop dogg
Saturday Night Special
For welding .080 and .090 outside corners??you just need more amps and larger filler
maybe more violence, stabbing it in there
Bc when I weld aluminum that's 99% of the time what I'm welding.
For welding .080 and .090 outside corners??you just need more amps and larger filler
maybe more violence, stabbing it in there
I usually put some dawn soap in a cup of water, and rub some between connections, or on hoses. If there is a leak you see it start to bubble.I have found leaks by putting it all in a bucket of water
just coil it all up and drop it on there and kick your gas on
a pin hole will haunt you
Are you just shoving that whole setup through the front?
I hope I have something backwards.
Took another look at the amazon link for your welder... I bet this is it
Read this review and watch the video: Amazon.com
*collet body and cupLeave the lense and diffuser mounted to the front
Id run at 15cfm
then swap a tank out if that doesn't work
and just because
your gloves are clean? You are log holding your rod in the gloves that you were scraping grease with were you ??
Post up a pic of the weld.
I think my flow is 25 cfm.
yall must be made of moneyId run at 15cfm
Old job I had that fucker cranked to 35-40 all day long. Had to compensate for someone opening the 40’ tall roll up doors and it’s windy around here. One door was 19’ wide the other was 35’ or soyall must be made of money
25 cfm is 1500 cfhOld job I had that fucker cranked to 35-40 all day long. Had to compensate for someone opening the 40’ tall roll up doors and it’s windy around here. One door was 19’ wide the other was 35’ or so
oops, edit made25 cfm is 1500 cfh
Aluminum filler on steel baseAny closure on this issue?
OP cant hear you because he is still grindingAny closure on this issue?