Newbie cutting torch question (it’s Tuesday)

[sdmuleman]

This is not going to end well.

Seriously dude, try to do some actual research - this isn't at all hard, and you clearly have either done nothing to help yourself or lack the iq to operate anything more complex than a small hammer.

 

[Steve300xcw]

Seriously dude, try to do some actual research - this isn't at all hard, and you clearly have either done nothing to help yourself or lack the iq to operate anything more complex than a small hammer.

Pretty sure that was why he made this post, and asked questions on wtf to do

 

[70 tp]

Did he go and blowed himself up yet? Been quiet

 

[Steve300xcw]

very possible

 

[[memphis]]

None of you assholes told him A before O or up you go! In regards to turning off the torches. He dead

 

[Gbkeith]

I never knew there were any tips other than Victor.

 

[Steve300xcw]

I never knew there were any tips other than Victor.

There are. Just nobody uses them

 

[TrikeKid]

 

[WoodburyZuk]

I’m good. I’m pretty sure the red zone reading was a fluke. I think it had something to do with the fact that the main knob was turned off. Anyway after you all berated me I went to double check and it was right where it should be (10-11ish).

Anyway. I got it dialed, watched some YouTube, I am gonna get new hoses this week.

Thanks y’all, even the ones who called me a low IQ mouth breather.

 

[Steve300xcw]

Dont get crazy with the heat when you are cutting that thinner iron. More isnt always better.