HF sells one similar. While nicer than cranking on a handle, they're nothing like a true hydraulic pump. And you need a good bit of air to run them continuously.It's on ebay as "Air Hydraulic Foot Pump 10000PSI w 6ft Hose and Spray Gun 3/8"NPT for Car Repair"
Long link:
Air Hydraulic Foot Pump 10000PSI w 5ft Hose and Spray Gun 3/8"NPT for Car Repair | eBay
The air hydraulic pump features a 1/4" NPT air inlet and a 3/8" NPT oil outlet, which will not leak oil easily. The user-friendly foot-actuated design provides hands-free operation. 1.6L Oil Tank & 4.1 ft Hydraulic Hose & with Spray Gun.www.ebay.com
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Is it possible to hook hook an electric Hyd pump to a manual Hyd press?
- Thread starter 2020AT4
- Start date
JohnnyJ
Low Range Drifter
Yeah, I can see that. My compressor seemed to hold up, but I'm using the press at hobby level for sure. It didn't mind bending two 6.5" wings on a 1/4" plate. Might be best to keep the hydraulic pump on the tube bender for that reason.
I have the air over hydraulic jack on my 20 ton press, but don't have my air really plumbed in yet so it's easier to just jack it off instead of running the air hose to the opposite side of the shop.
A few friends and I just went in on a tube bender and someone already bought the air over hydraulic ram for it. I'd almost rather crank the handle than wait for that slow thing to che che che it's way in to a bend.
subybaja
E. Spengler
Offtopic FYI- I just got one of these for $120 from Amazon Warehouse.
Air Hydraulic Bottle Jack, 32 Ton
Vevor = ChingorFreight, but we'll see. 30t air have been $400 forever.
Air Hydraulic Bottle Jack, 32 Ton
Vevor = ChingorFreight, but we'll see. 30t air have been $400 forever.
JohnnyJ
Low Range Drifter
Biggest brake yet. 26” wide on 7-gauge (0.179) at about 30-tons on the dial. Was relieved when it was done.
