Hydro hose routing

[mongosd2]

So how are you guys routing hoses to the ram?

 

[Byro]

Big swooping loop.

 

[DesertCJ]

I run mine down the upper link. Some billit aluminum clamps would be nice like I have for my brake lines but I just used zip ties. Not very fancy but they work…

 

[mongosd2]

Yeah that’s how mine are routed now and just looking for ideas or a better way…

 

[94toytruck]

Mine are pretty short.

 

[Bebop]

Along upper link

 

[chaplinfj60]

i did the longer loop out front but switching it up to go down the upper link.

 

[TX_Jeep]

Upper link here as well. Used these clamps to mount brake lines and hydro hoses to the link. Cheap and look a little better than zip ties.

Poly Performance Line Clamp Kit

 

[Simple'72CJ]

Bought these from AJK offroad a few years ago

 

[welndmn]

Down the trac bar.

 

[pennsylvaniaboy]

These are nifty from motobilt

Zip Tie Mount for Round Tube DIY Builder Parts

 

[Bebop]

How do you adjust your links with this ?

 

[chaplinfj60]

who made some 3d printed ones before?

 

[Wisconsinite]

I printed these for the rear axle on my rig, small hose is the -3 ARB pressure line, and I went with a -6 vent(stupid). These were designed for a 1.75" link, and the hoses rise above the surface .020" to make sure they are clamped well. You can see a slight groove in the OD for a hose clamp.

I made this one for the front of the rig for the two hydro lines and a 3/16 brake line. This was printed out of a polycarbonate blend, and as the illustration would show, I can stand on them with out failure.

 

[chaplinfj60]

nice and thanks i was just going through your thread because i thought you did this.

 

[the_white_shadow]

How do you adjust your links with this ?

How many times do you adjust your links after setting them up? Zero i bet.

 

[Bebop]

How many times do you adjust your links after setting them up? Zero i bet.

once every 2 years or so when I change the heims

 

[pennsylvaniaboy]

How many times do you adjust your links after setting them up? Zero i bet.

Plus the mount can be zip tied or hose clamped or rack welded… Bebop