grumpy356
bordering on illiterate
- Joined
- May 19, 2020
- Member Number
- 244
- Messages
- 1,152
60mm gauge and it just barely doesn’t fit in the hole in the panel. Does anybody have a source for a grommet or a doughnut?
I can try to cut one, but because it needs to be kind of tight, I don’t think it’s going to be real easy.
I tried to just caulk it in place and there’s too much wobble and it gets too messy to get an acceptable result.
A lot of times I post these threads and y’all have a real simple solution that I’ve just overlooked, and I’m hoping this is the case.