I am looking to dimple some 1/8" plate for a project. I would like to be able to do up to 3/16. I have access to a 25 ton press, I figure that should handle 1/8 fine but dont know how much pressure you need for anything thicker
Any tips on dimple placement? Staggering hole sizes... is that just for aesthetics? How far away from an edge can/should you put a dimple?
I saw ruffstuff has a set with sizes I would likely use, some other ones on eastwood say they only handle 1/8". What other brands should I look at? What are the downsides of a "cheap" set?
Any tips on dimple placement? Staggering hole sizes... is that just for aesthetics? How far away from an edge can/should you put a dimple?
I saw ruffstuff has a set with sizes I would likely use, some other ones on eastwood say they only handle 1/8". What other brands should I look at? What are the downsides of a "cheap" set?