its still tuesdayWhatcha think?? Is this ball wasted? Replace it or clean it up and run it?
-
If you don't frequent the chat forum, make sure you read this post regarding land usage. It would be great if we could get everybody to send a comment in before Oct 7th!
Balls
- Thread starter Beefmaster
- Start date
its still tuesdayWhatcha think?? Is this ball wasted? Replace it or clean it up and run it?
- Joined
- May 26, 2020
- Member Number
- 1507
- Messages
- 1
As long as the seal area is good run it
Agreed. Clean up the seal mating surface, pop in a new seal and yer good to go
Run it. I would maybe take the sharp edges off with a die grinder, or maybe not.
Run it
Clean it up a bit and run them, as long as the seals are good it will be fine.
Here is one of mine after I grenaded a birf and drove back to camp during KOH. Cleaned it up, put new a new seal in it, and shes solid
Cleaned up with a dremel and a sanding flap wheel in a drill until it was smooth to the touch
Here is one of mine after I grenaded a birf and drove back to camp during KOH. Cleaned it up, put new a new seal in it, and shes solid
Cleaned up with a dremel and a sanding flap wheel in a drill until it was smooth to the touch
Thanks guys! Got her all cleaned up with a dremel. Gonna pop in a new seal and send it
yeah it isn't like the birfield of anything is actually supposed to ride on the inside, hell even the burrs and shit are probably not a big deal. i highly doubt they would last long if the birf did run them.
seal housing and clean top and bottom for the bearings is all that matters.
seal housing and clean top and bottom for the bearings is all that matters.