My wife inherited this 5 legged table from her grandmother. It looks to be complete other than it's missing a leaf and one of the clips that holds the leg in. The clip is what I'm after, but I have no idea what it would be called or where to start looking. Was hoping someone here might have some sort of insight. Thanks!
5 legged table missing hardware. ID help
- Thread starter JpZombie
- Start date
- Joined
- May 19, 2020
- Member Number
- 124
- Messages
- 1,619
That's a dickfer.
What's...that...for...?
- Joined
- May 25, 2020
- Member Number
- 1362
- Messages
- 2,072
Does that go in the corner on the 45* piece for tension? If so a large, fat washer or two should work. You could drill 2 holes fro screws and zip out a slice for the shank to slide into.
Check here https://www.rockler.com/shop?w=hanger+bolt
Check here https://www.rockler.com/shop?w=hanger+bolt
Last edited:
Thank you just what I needed some place else to spend my day at
Correct. The leg has the bolt screwed into it and then the bolt goes through the 45* piece and the two tabs lock it into place. The washer plan was going to be my back up if I couldn't find something like the original piece. But also looks like I could make those corner brackets work if it came down to it.
Or try van dykes. I'm sure they'd have it.
https://www.vandykes.com/?gclid=Cj0...tlpufICAJU5Esik1hMB9qwJzKi4oftCkaAhNyEALw_wcB
https://www.vandykes.com/?gclid=Cj0...tlpufICAJU5Esik1hMB9qwJzKi4oftCkaAhNyEALw_wcB