CA 1973 F250 highboy

[1Sinner]

As the title says, 1973 F250 high boy (true F26 vin truck) listed in powertrain, as I can sell on bill of sale, but it was a buddies that passed and the title was lost years ago.

390fe, C6, divorced np205, low pinion dana 44 front, dana 60 rear. It's not pretty, but could be made to run. Lower cab corners, doors, and lower fender rears are rusty as typical for those years. Bench is in it, tank is in it, dash is complete. Easily turn it into a back half crawler. Or get a donor truck and body swap. First 800 takes it. Will give bill of sale. Going to list on Facebook for 1200 as it is a real high boy, and pre smog.

 

[Projectjunkie]

If we made a deal, and I could figure out transport... and paid, could it sit there for a couple months, do you have any equipment to push onto a trailer?

 

[1Sinner]

We can make a deal, and it can sit here, no issues. Just need a timeline. We could rig a winch or some chain falls to pull it onto a trailer. Whatever you wanna do bud. Just pm me. Rather it go to someone here than a rando anyway.

 

[Masterbeavis]

Know anyone with parts for one of these kicking around in the NorCal area?

 

[1Sinner]

Know anyone with parts for one of these kicking around in the NorCal area?

I don't unfortunately

 

[Grendel]

Moved to "vehicles".

 

[akguy09]

Positive it has a 390? Should be a 360....When I was dealing in and working with Highboys they all get a 390 when they are for sale.

 

[Projectjunkie]

Positive it has a 390? Should be a 360....When I was dealing in and working with Highboys they all get a 390 when they are for sale.

Well, it's for sale, so it's a 390

 

[1Sinner]

Positive it has a 390? Should be a 360....When I was dealing in and working with Highboys they all get a 390 when they are for sale.

I can pull the vin and block codes again and double check, but I'm 95% positive

 

[Projectjunkie]

I can pull the vin and block codes again and double check, but I'm 95% positive

Don't bother, rule of thumb was no 4wds got 390s, and even block numbers don't reflect the crank and rods that are in it at this point, only real way to check is by putting a piece of wire in the spark plug hole and measuring stroke, to find out its a 360

 

[Levigarrett76]

Don't bother, rule of thumb was no 4wds got 390s, and even block numbers don't reflect the crank and rods that are in it at this point, only real way to check is by putting a piece of wire in the spark plug hole and measuring stroke, to find out its a 360

Oil dipstick works well for this