3rd

I put PRP seats in my 2001 SR5 last week and am curious if anyone knows how the airbag system works without the seatbelt and weight switch in the OEM seat being plugged in. As in, if the airbag system sees both the seatbelt circuit and the weight sensor circuit as open, will it still fire the...

This is mine and my nephews build. Slowly turning into more of my build as its in my garage and they are not able to help as much. (Turning into young adults). Was in a limestone mine so not rusted out bad but definitely has some cancer here and there. Plan is to swap to leaf springs in the...

I Just picked up a '96 3rd gen that has a rear arb, full skids, 4.88's and some nice armor and a winch. Having completely destroyed my 80 series rig to the point where it can only be trailered, and has no glass, I wanted something a little more kid-friendly as I am now wheeling with 2 little...

To my surprise the guy wrote back 3min later and said $1200 shipped... So now I am in trouble and in over my head. I did a solid axle swap on my 4runner back in 2012 and I am running a forward swing 80 series box, so I knew I would be on my own for figuring out how to fit it. Build thread...

Anyone know good sources for rear springs? I think mine are sacked on my 2008 5500. I put some Timbrens to help, but it's riding almost on them and is on the stock helpers without a load.... just the 1500-maybe 2k lb flatbed. The spring kind of look like my drawing, don't think that's normal...

Is there anything worth doing to a 4wd Cummins truck to achieve something less of a locomotive like ride quality? I’ve done new Moog control arms, bilstein 5100 shocks and 50psi in the tires. I’ve seen Thuren soft ride coils but those give you a lift I don’t care for.

So, short story long: I made some plates for my reloading presses so that they all mount to the same 4 holes through my bench. I then realized that I should make a plate for my 5" wilton vise (it took an 8x8 plate vs an 8x5 plate, so 2 more holes further back, whatever). , while mounting the...

Have you ever had the desire to turn your 3rd gen 4Runner from something that's respectable, desirable, high value, a decent off-roader, and a great family vehicle, into something that's not? Then this is the thread for you. This build, which I'm dubbing "Rocks & Flops", will show you the...

OEM Toyota elocker 3rd member out of a Tacoma, 4.10 gears, in good condition, locker works without issue. This 3rd member can be retrofitted into any Toyota 8" axle from 1979-2015 (did the 4runners continue to have an 8" past 2015?) $600 OBO Located in Whitmore Lake, MI 48189 Can ship on...