Balls

Collapse
X
Collapse
First Prev Next Last
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Balls

    its still tuesday

    Whatcha think?? Is this ball wasted? Replace it or clean it up and run it?

    #2
    As long as the seal area is good run it

    Comment


      #3
      Agreed. Clean up the seal mating surface, pop in a new seal and yer good to go
      Jack of all trades, master of fuck all.

      Comment


        #4
        Run it. I would maybe take the sharp edges off with a die grinder, or maybe not.

        Comment


          #5
          Run it

          Comment


            #6
            Clean it up a bit and run them, as long as the seals are good it will be fine.

            Here is one of mine after I grenaded a birf and drove back to camp during KOH. Cleaned it up, put new a new seal in it, and shes solid



            Cleaned up with a dremel and a sanding flap wheel in a drill until it was smooth to the touch


            Comment


              #7
              Thanks guys! Got her all cleaned up with a dremel. Gonna pop in a new seal and send it

              Comment


                #8
                yeah it isn't like the birfield of anything is actually supposed to ride on the inside, hell even the burrs and shit are probably not a big deal. i highly doubt they would last long if the birf did run them.

                seal housing and clean top and bottom for the bearings is all that matters.


                Up is difficult, down is dangerous

                Comment

                Working...
                X