What's new

Replacing 14 mm studs with 9/16 studs in a 14 bolt.

TTMotorsports

Red Skull Member
Joined
Jan 7, 2021
Member Number
3315
Messages
536
Location
Santa Maria, CA
I changed them out years ago and don't have the part # but I had a local napa look up the 14mm stud knurl size and length, and then looked in the book for close size and found some and they ordered them and worked like a charm. No help with part # but that's what I did and they had a book at napa and were able to look up studs by thread size and it was sorted in knurl diameter to match it up.
 

TTMotorsports

Red Skull Member
Joined
Jan 7, 2021
Member Number
3315
Messages
536
Location
Santa Maria, CA
I believe these are close.

Dorman 610-419.1


I looked it up by year/make/model of the truck axle you have then convert mm to in and then search by size to find equivalent.


 

YotaAtieToo

Thick skull
Joined
May 19, 2020
Member Number
142
Messages
3,869
Location
9B
I believe these are close.

Dorman 610-419.1


I looked it up by year/make/model of the truck axle you have then convert mm to in and then search by size to find equivalent.


Those look right iirc.

I also wanted to use slip on rotors since the 14b had slip on drums. Studs might be different if you want to go back to shitty press on rotors.

I'll dig through my pics and see what I can find.
 

TTMotorsports

Red Skull Member
Joined
Jan 7, 2021
Member Number
3315
Messages
536
Location
Santa Maria, CA
yeah when I converted the truck from metric to 9/16 I ran a dodge ram slip on rotor and made new caliper mounts and it worked great. Ditched the press through studs holding the drum/rotor on and went with a slip on rotor setup. Worked great.
 
IH Parts America - CPT Crawler Proven Technology

Register and these ads Disappear!

Top