VA One tons and Toyota “one tons” FJ80 axles. Winchester, VA

[Covecrawler]

SRW Chevy dana 60, unknown ratio, no lockouts. $1000

Cut down Chevy dana 60. 63.5” WMS. Was setup for FJ spring width. 3.73gears. Has DRW hubs with flanges torched off. Will need to be machined or new hubs. Needs long side shaft made. $600

1995 Ford F-350 cab and half of a frame. Locked up 7.3l, ZF5, DRW 4.11 dana 60. I saved this to used as a 5 speed swap and f250 SAS. $1500

FZJ80 axles with additional parts to be installed.
-5.29 gears for HP front and 9.5” rear
-solid pinion spacers and minor install kits
-lunchbox lockers
-OG longfields
-superwinch hubs and drive flanges
-knuckle seal kit
The axles have ABS, full float rear axle, control arms are on the axles, but missing one front lower.
$3200

2004 14b FF 4.11 with disc brakes, SRW $300

2005 Chevy van SRW dana 60 4.11 SF $300

2005 Chevy dually van dana70, 73.5” WMS, unknown ratio. Missing calipers. $500

1979 Chevy K20 rolling chassis. Dana 44, 14b FF $500

7.17 used LP dana 60 gears $100

225SL29B dana 60 35 spline Detroit locker 4.10 down or use with thick gears. $700 shipped​

 

[Rockbuggy84]

Would you possibly crate and ship the gm 60 to California?

 

[Covecrawler]

Probably not, I’m short on time to mess with freight. Sorry.

FZJ80 stuff is all sold.

 

[flexy flatty]

FZJ80 stuff is all sold.

Mind if I ask if you got close to asking price on them? I have a set with similar build except factory locked and don’t want to underprice myself. Thanks

 

[Covecrawler]

Mind if I ask if you got close to asking price on them? I have a set with similar build except factory locked and don’t want to underprice myself. Thanks

I took $2500 for them. A little more of a hit than I wanted to take. It’s hard to say no sometimes to a guy flashing $100 bills.

 

[flexy flatty]

I took $2500 for them. A little more of a hit than I wanted to take. It’s hard to say no sometimes to a guy flashing $100 bills.

I get it totally