TrailCrush'r
Member
Selling a set of one ton axles and trusses for a JK/JKU. I’m changing directions with a few Jeeps builds. ‘07 f250 sourced front Dana 60. ’03 Chevy 14 bolt. I have the TMR trusses. Rear axle is basically done. Has pinion guard and tie in. Also has the Weld on high steer for the front. Front axle isn’t started other than stripped down so it’s easy to move.
Front - I haven’t cut much off of the front yet. Axle is disassembled so it will be easy to move. Wheel bearings and all break calipers are good. Axles and U joints are good. Will need break pads and rotors, small parts. Has 4.10 gears. Manual hubs.
Rear - most work is done. Axle is stripped. Truss is stitch welded and ready to be welded to the axle. Rear breaks are good, e-break works and have both cables, axles are good. Bearings are good as well but I was going to replace them. 4.10 gears as well.
Asking $2,200 for everything. I’m on the border of Oklahoma, Missouri, Arkansas. Will meet within a reasonable distance.
Front - I haven’t cut much off of the front yet. Axle is disassembled so it will be easy to move. Wheel bearings and all break calipers are good. Axles and U joints are good. Will need break pads and rotors, small parts. Has 4.10 gears. Manual hubs.
Rear - most work is done. Axle is stripped. Truss is stitch welded and ready to be welded to the axle. Rear breaks are good, e-break works and have both cables, axles are good. Bearings are good as well but I was going to replace them. 4.10 gears as well.
Asking $2,200 for everything. I’m on the border of Oklahoma, Missouri, Arkansas. Will meet within a reasonable distance.