ChiScouter
Red Skull Member
- Joined
- Jun 1, 2020
- Member Number
- 1753
- Messages
- 379
What a mess, I have a 04 3/4 ton suburban. It has 300k, typical midwest rust, and is nothing but a POS work/tow vehicle. I probably don't put 3k miles on it a year. Last trip the frame bent just behind the rear spring mount. It is the most stressed point of the frame and some brilliant engineer thought it would be a great place for a 3 inch hole. I just pulled the rear fuel tank to replace the fuel pump so I have a bit of room, There is nothing flat or that lends itself to an easy clean looking patch/brace job. I can get in only minimally with a wire wheel in the drill or angle grinder. I typically use ER70S wire but for this project I want to explore options and get a 15lb pound spool of something better suited if there is anything. I need this thing up and running very soon so I don't want to get into anything extensive.
Any wire recommendations?
Any wire recommendations?