What's new

MCI 102-C3 coach to RV - General/Floorplan

In the planning stage of how I'd like to mount the Verona wheel hub to the closets. I think I'll be mounting the WMS to the closet disc because it has more surface area to offer more support under the disc. Probably going to knock the pilot down on the lathe and turn either the ID or OD of the pilot to a diameter that I can match on my circle cutting jig for a nicely centered register.

I'm debating on what to do with the wheel studs, if anything. I noticed that the flange bolt circle looked about the same as the wheel stud bolt circle. Smacked a stud out and sure enough they match. Too easy. I can grab a bolt at ace to grind a centered point on and thread it into the flange to pass through a wheel stud hole to make an indention of where to drill for bolt holes to match the wheel stud pattern.

20210328_015949[1].jpg
 
Drew that Samsung fridge into the floor plan. The kitchen/den area plan isn't close to done yet. We may rearrange the front of the floor plan a bit.

bus floorplan.png
 
Top Back Refresh