- Joined
- Sep 9, 2021
- Member Number
- 4387
- Messages
- 2,828
Thought I posted this here, but I guess not. It oughtta make a few folks cringe
Grabbed a t3 lite 223 a while back. Its probly going to end up as a beater truck gun.
I like shorter barrels, so I cut it at about 18". Cut it at a bit of an angle, cuz if it still shot good. It would break my brothers mind, cut the crown with a die grinder
223 on a long action and you still cant run anything long. So AICS, and then opened those up. Can now jam a 75eld into the lands with room to spare
CNC router for the bottom metal
Bought the mountain tactikool bottom metal because that is what was available. I fucked up doing that. The mag release hangs way down below a 5 round mag. Now that I own the thing, I see ctr bottom metal everywhere for aics mag's with a decent mag release oh well, I'll hack this one up first an then maybe replace it down the road a bit
6x swfa that I had handy.
Tossed 26gr of lever into some very used and very mixed brass. Using 75gr eld seconds. Its shooting just over an inch right now. Need to bed it, and then load some actual decent rounds for it.
Grabbed a t3 lite 223 a while back. Its probly going to end up as a beater truck gun.
I like shorter barrels, so I cut it at about 18". Cut it at a bit of an angle, cuz if it still shot good. It would break my brothers mind, cut the crown with a die grinder
223 on a long action and you still cant run anything long. So AICS, and then opened those up. Can now jam a 75eld into the lands with room to spare
CNC router for the bottom metal
Bought the mountain tactikool bottom metal because that is what was available. I fucked up doing that. The mag release hangs way down below a 5 round mag. Now that I own the thing, I see ctr bottom metal everywhere for aics mag's with a decent mag release oh well, I'll hack this one up first an then maybe replace it down the road a bit
6x swfa that I had handy.
Tossed 26gr of lever into some very used and very mixed brass. Using 75gr eld seconds. Its shooting just over an inch right now. Need to bed it, and then load some actual decent rounds for it.