Anyone in here done it ? Any recommendations on film to use and where to buy ? I have some interior car parts I need to do.
Hydro dip ?
- Thread starter rockmup
- Start date
- Joined
- May 19, 2020
- Member Number
- 124
- Messages
- 1,619
Rattle can it and move on.
You can rattle can the water and then dip
- Joined
- May 21, 2020
- Member Number
- 1083
- Messages
- 4,600
What's hydro-dip? Electrodeposition?
Seems like electrodep should be taking over the small powder-coating job shops by now. Must be the environmental chemicals drive the cost up too much, but for box frames and other like parts it's superior. I saw them electrodep stuff that's pretty intricate, but what do I know I just worked on the computers there.
Seems like electrodep should be taking over the small powder-coating job shops by now. Must be the environmental chemicals drive the cost up too much, but for box frames and other like parts it's superior. I saw them electrodep stuff that's pretty intricate, but what do I know I just worked on the computers there.
I've seen that before, actually pretty slick but I need some fake carbon fiber trim work done to get rid of the chrome.
- Joined
- May 21, 2020
- Member Number
- 1083
- Messages
- 4,600
I realized that after I re-read the thread.
Yeah I know that process by another name. I don't have anything to offer better than a YT video. We did all the wood grain in Lexuses, they were very good at it, but I don't know the process better than a couple of guys on your video.
Electrodeposition was what I was babbling about. Basically powder-coating in a water based solution.
