Grinding standard 1350 double cardan

[Winchested]

I know this has been around a long time.

Just wondering if anyone has photos or a guide they can share on where to grind.

Put this 1350 adams shaft in my front and I'm thinking I should have got a high angle one made...

Can I remove the seal to get a bit more angle.

4x4 is only used offroad on this rig.

Looks like with it installed I only have about 4-5" of down travel on it before it binds.

 

[PoBoy84]

I know this has been around a long time.

Just wondering if anyone has photos or a guide they can share on where to grind.

Put this 1350 adams shaft in my front and I'm thinking I should have got a high angle one made...

Can I remove the seal to get a bit more angle.

4x4 is only used offroad on this rig.

Looks like with it installed I only have about 4-5" of down travel on it before it binds.

Check this thread out.

Neapco 1350 CV angle

Does anyone have experience with Neapco 1350 CVs? They are claiming 32 degree max angle...that seems high and I thought achieving 32 degrees requires custom clearancing and considered high angle stuff. Can anyone confirm/deny? I’m running a single u joint on each end right now that pulls 30...

irate4x4.com

 

[pennsylvaniaboy]

Neapco 1350 CV angle

 

[Winchested]

Thanks fellas!

 

[Winchested]

Well that thread was a shitshow haha. But I get what I need to do now!


I actually now remember doing this to my 1310 CV when I got it from them.