OR Dana 60/Toyota hybrid axle kit

[Mr Stubs]

This is a conversion kit that will allow you to run a Dana 60 axle and 35 spline axle shafts in the rear of a Toyota truck or crawler that six lug wheels are desired
​​​​​​. Comes with mounting brackets that will accept a Willwood brake caliper coupled with a Trail Gear or Spidertrax slip on rotor.

NW Or 97133

purchaser picks up shipping.

$300

 

[YotaAtieToo]

This is a conversion kit that will allow you to run a Dana 60 axle and 35 spline axle shafts in the rear of a Toyota truck or crawler that six lug wheels are desired
​​​​​​. Comes with mounting brackets that will accept a Willwood brake caliper coupled with a Trail Gear or Spidertrax slip on rotor.

NW Or 97133

purchaser picks up shipping.

$300

Fwiw, i have a smooth bottom D60 housing with 3.5" tubes that will accept theses axles. I'd sell for cheap. Not trying to hijack, just figured it might help the sale.

 

[Mr Stubs]

Fwiw, i have a smooth bottom D60 housing with 3.5" tubes that will accept theses axles. I'd sell for cheap. Not trying to hijack, just figured it might help the sale.

No problem, and thanks.

 

[Rangerrod]

What was over wms-wms?

edit I know you can narrower by chopping them down.

 

[Mr Stubs]

What was over wms-wms?

edit I know you can narrower by chopping them down.

These shafts are uncut. I believe they are 30” long and have 4” worth of spline. Iirc I was running a 62” WMS in the rear on the crawler.

 

[YotaAtieToo]

These shafts are uncut. I believe they are 30” long and have 4” worth of spline. Iirc I was running a 62” WMS in the rear on the crawler.

Mine was 62" wms also.

 

[Adamwende]

Going rear steer???!!!

 

[Etyler2]

Fwiw, i have a smooth bottom D60 housing with 3.5" tubes that will accept theses axles. I'd sell for cheap. Not trying to hijack, just figured it might help the sale.

Tell me more about this cheap 60!

 

[YotaAtieToo]

Tell me more about this cheap 60!

Started as a ~2000 E 250 rear semifloat smooth bottom D60U (had to sand down a normal D60 cover because the flange hung down ~1/4", so about 1/2" more than most 60s). Cut it down to use the kit Stubs listed. Used an alignment bar and all. Ran for about 8 months and the rig burned up. I saved the axles and tcases. Front axle and tcase still had gear oil, rear did not. It's 3.5x375 tubes, I'd think they would be fine, but that's up to the buyer. I lost the 6 lug beadlocks in the fire and decided just to go to an 8 lug full float rear.

It can use any toyota rear brake setup. I used the generic gm rear disc brakes and still have the brackets.

I'd let it go for like $100 to someone on here. I can eye down the thing again if you want.

 

[Tommybrinkmann]

Still have the shafts? Any clue on shipping cost to 93030?
can call or text me if it's easier 805-407-5415 Tommy