just realized what hes doing, yea that aint happening
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Axle alignment bar and pucks
- Thread starter Snoop dogg
- Start date
-
- Tags
- newb
just realized what hes doing, yea that aint happening
Snoop dogg
Saturday Night Special
Yes whatever is holding it bent needs to be cut, then jacked to straighten. You'll just fight it if not
Edit: and noticed your table....even if you cut off the truss welds that table doesn't look "stiff" enough for the axle to bend straight....the table looks like it's what's gonna bend when you pump the jack.
Edit: and noticed your table....even if you cut off the truss welds that table doesn't look "stiff" enough for the axle to bend straight....the table looks like it's what's gonna bend when you pump the jack.
desertPOS
Red Skull Member
- Joined
- Jul 2, 2020
- Member Number
- 2236
- Messages
- 331
First thing I'm doing in the morning is going to buy more bottle jacks
Joking. I already mentioned cutting the truss - I worked on this for about an hour today after not even seeing it for the past month. Going to check the tubes first to make sure they're not bent, and if they're good go from there...
Joking. I already mentioned cutting the truss - I worked on this for about an hour today after not even seeing it for the past month. Going to check the tubes first to make sure they're not bent, and if they're good go from there...
Landy_Andy
Active member
Gonna make my alignment bar out of 1.5” DOM & fill it with some ‘Target Fine Traffic Patch’ concrete to give it added stiffness.