CA 6 lug D44 Outer stuff/E. Bronco inner shaft

[MochaMike]

Building an axle & parts got stolen from side yard of shop.

I’m hoping someone is doing a conversion to 5 or 8 lug.

Need:
2 Spindles (Waggy/Chevy…. Iirc small bearing/cheap ones/not for 5 lug conversion)
2 hubs (6 lug, Jeep/Chevy)
2 caliper brackets

Won’t say no to good rotors as well or small parts (bolts/studs/bearings etc)

Located in SF Bay Area preferred.
I cruise up 80/50/88/4 every month or so, so I could pick them up.


I can pay you a bit of cash (used whole axles are $2-300…..so…). Or trade some fresh veggies or incredible salsa, pasta sauce or cowboy candy (I can stuff).

 

[MochaMike]

For those interested: it will be a Chevy D44 narrowed on long side to take an early Bronco long side shaft, to match a Waggy rear.
This moves pumpkin in so leaf springs don’t need to be outboarded to fit a flatty frame/body.

 

[urjb]

I got tons of that shit up in Petaluma.. but I’m not headed there for a few weeks.. you in a hurry?

You going 6 lug? If so you can use either spindle,. I’d go with bigger is better.

 

[total newb]

Ive got a complete 6lug 10b setup.

I also have flat top knuckles.

 

[MochaMike]

I have knuckles & arms already