drop

Ford 205 case Chevy 32spl input, slip yoke rear output and flange front output. Gears, shift rails, counter-shaft, bearing retainers, everything. Tiny bit of rust on the countershaft but nothing I wouldn't run if I wanted to run a 205. All the parts are loose and out of the case. Asking...

Looking for a solution to prevent generator voltage drop for my Primeweld MIG and TIG 110/220 welder running around 30-50A. Anybody try capacitors or other DIY solution? It only lasts a couple seconds after initial arc, then generator ramps up, just enough to throw me off. Currently I start...

Looking for a Passenger drop Waggy 44 in Dayton, OH.

So I have a 7.3L ZF-6 with fresh clutch and total rebuild. Also have the 271 that came behind it. It's 24 spline. I am sticking this behind a 6bt Cummins in my 1941 Chevy G506. I bought a passenger side drop 14B front from TTRAxle&FAB with all the goodies. He's re-building, cut him some...

Curious to see if anyone has turned an 05+ Superduty 60 from driver side to passenger side drop. With the supply of kingpin 60's running out and prices going ridiculous, then being able to pick the 05+ superduty 60 in my area for terribly cheap I'm seriously considering doing one on the next...

Looking for a divorced Ford NP 205

Hey guys looking into doing a drop tailgate conversion on my yj, but I'm curious about thoughts between the swag and the motobilt kits, thanks

New TTR 14 bolt front. Built wrong for customer and want it out of my way Bare housing with just American Iron Cs Passenger drop New 4in Casting with 4x.500wall axle tubes American Iron Offroad Inner Cs 13 bolt shave 73.5in wide wms 10⁰ of pinion 7⁰ of caster $1500 Location is Villa Ridge...

‘94 241c drivers side drop w/ 32 spline input. JB conversions 1350 yoke SYE Does not shift to 4wd. 2wd works fine. $450 located in Yukon, OK I currently travel between OKC and Austin, TX weekly I can make a stop if need be.

Older 3.8 atlas, needs a rebuild, has worn thrust bearings and some roller bearing play. Includes full new in box rebuild kit. Currently has 32 spline gm input but will include 23 spline as well. Has 1 1350 yoke and I have 2 new toyota flanges as well. (I may keep these if they will work with...

Credit to Randall E. from GrabCAD