|
Bend-Tech EZ3D
Bend-Tech EZ3D was designed to help out the serious hobbyist. We took our easy to use EZ product and added a 3D interface. Our Tri-Star interface is unique in that a customer doesn't need to learn XYZ, it uses terms like front, back, floor, ceiling, left and right. While you are stepping quickly around the part, EZ3D is calculating your bend angles and rotations. No more guessing.
Max bends per part: 6
Key Features:
Designer: Sketch 3D
| Designer: Harpoon
|
Designer: Custom Part 3D The Custom 3D Part interface allows you to enter the definitions of your part in a sequence following the center line of the material. Directional terms are easy to understand for creation of the part. These terms are; left, right, front, back, ceiling, and floor. The bend angles and rotations are automatically calculated. | Bending Simulation Simulation helps the fabricator visualize the bending process before running the part through the machine. This helps to confirm the manufacturability of the part and the bend order. (*Does NOT check for collision.) |
Bend Order Manipulation Bend from either end, flip the part between any of the bends, or do a custom sequencing. Verify your sequence using the Bending Simulation. | Designer: Custom Part Create a part by starting at one end and entering the distance between bends, rotations between bends, and the angle for each bend. The length values can be apex or tangent values. |
Designer: Sketch 2D
| Designer: Templates Choose from dozens of predefined templates. The templates are easy to use and in seconds you will have your design completed and be ready to start bending. |
Designer: Custom Part 2D Create a part by starting at one end and then entering in the distance between bends and the angle at each bend. The length values can be apex or tangent values. Custom Part 2D allows bends to reverse direction (180 degree rotation). | Material Library The Material Library includes material shape, size, wall thickness, color, and weight. |
Die Library Define your dies within the software. Definition includes CLR, Calibrated CLR (stretch factor), and Bend Location Offset. | Bend Calculation Output Software will provide cut length, bend locations, bend angles, and rotations for every parts you have designed. Each bend location is based from the end of the tube. |
Post Bending Cutoff Cutoff allows extra material to be added at the end of the tube for cutting after bending. The cut length and bend locations are automatically adjusted for cutoff values. | |
| Bend-Tech software requires an active internet connection in order to activate the license on your computer, and then every 6 months after. SE software can run offline in between. Minimum Requirements:
Recommended Requirements:
MacOS Requirements:
| |
