Attached .stl is for 2.50"OD 3.00"CLR as shown in update.
I can make these in whatever OD and CLR combination you need. Also, any file type that can be exported from Catia or NX (damn near anything).
I can also make the letters raised to make multi color printing easier. I recessed them to reduce the chance of them wearing or breaking off.
Additional holes added for hanging.
Any feedback would be appreciated.
Pin fit it R +.02mm. too tight? too loose?
Tube fit is line to line.
Do marks need to be longer?
Do the letters and number need to be cleaned up to reduce the number of faces?
Should I add some material saving pockets to the base?
Does the arm stay secure in the pocket of the base?
I can make these in whatever OD and CLR combination you need. Also, any file type that can be exported from Catia or NX (damn near anything).
I can also make the letters raised to make multi color printing easier. I recessed them to reduce the chance of them wearing or breaking off.
Additional holes added for hanging.
Any feedback would be appreciated.
Pin fit it R +.02mm. too tight? too loose?
Tube fit is line to line.
Do marks need to be longer?
Do the letters and number need to be cleaned up to reduce the number of faces?
Should I add some material saving pockets to the base?
Does the arm stay secure in the pocket of the base?