1985 auto with dual cases and triple sticks

85yotapolo

Member
Joined
Nov 30, 2025
Member Number
9679
Messages
8
anyone have pics of this
made a "Plug" to fill the cavity left in the tail housing. I used a piece of tubing (6" or 8" in think. its been in there for years) capped the ends and put a smaller tube in the center for the output shaft. It shaped like a big metal roll of toilet paper. BTW I removed the VSS magnet setup off the output.
Try to take up as much volume in the tail housing as possible and make the "Plug" fit tight. I welded some little spacers on the outside of the plug to wedge it tight in the case.

for those running this adapter ?
 
IMG_4014.jpeg
 

Attachments

  • IMG_4013.jpeg
    IMG_4013.jpeg
    2.4 MB · Views: 50
  • IMG_3999.jpeg
    IMG_3999.jpeg
    1.9 MB · Views: 54
  • IMG_3997.jpeg
    IMG_3997.jpeg
    2.6 MB · Views: 55
going to run the FROR skid plate and crossmember, got the new 2.28 case to 4.7 had twin sticks with the 4.7 but gonna run triple with new setup. while doing this i want to make it better on those step inclines. try and make block off plates for trans to help with fluid going back,
 
Dat's gotta be a long ass setup.
Bring the tech
 
Dat's gotta be a long ass setup.
Bring the tech
Lol yeah gonna be little longer LOL. That's why I want to run triple sticks so it's not far back. See how this goes.
 
  • Like
Reactions: Clb
anyone got pics of what they did, auto with inchworm adapter to help with fluid, i already tried to make those baffles and block off plates to keep fluid from going back and filling that cavity, just wondering what other ideas you guys got
 
I have no input other than it’s a damn shame Inchworm is no more.
 
  • Like
Reactions: Clb
Was inchworm the 5 bolt doubler?
 
triple sticks should be here this week ill post of pics when they come in, once i get them on gonna try and toss it up and start mock up for rear crossmember
 
Just hang it on the rear axle:flipoff2:
 
Top Back Refresh