N. Calif: driver drop LP front Dana 60 many new parts

First Prev Next Last
  • Filter
  • Time
  • Show
Clear All
new posts

    CA N. Calif: driver drop LP front Dana 60 many new parts

    Short: Located outside of Georgetown, Calif. I'd like $2200 for it. Depending upon location and how much you are paying, I can drive a bit to drop it off. Otherwise, shipping will be extra and potentially up to you to arrange.

    - Low pinion Dana 60 that is converted driver drop and 67" WMS using stock Dodge inner shafts
    - Knuckles turned for 10 degree pinion up
    - New Spicer 35 spline outer shafts and full c-clips includes new Spicer SPL55-3X ujoints
    - ECGS 35 spline drive flanges
    - 5.86 gears on open diff with new Yukon install kit (gears were installed in housing when I bought, I wanted new gears)
    - Knuckles, spindles, and brake dust shields cleaned/painted includes new knuckle bearings
    - Dirty stock Dodge internal hubs includes new in box brake rotors and new wheel bearings/seals
    - New 'dirty' Ruff stuff diff cover
    - Ruff stuff bronze kingpin bushings
    - Sky Manufacturing high steer arms including new install studs
    - Stock tie rod with new tie rod ends

    Other parts available to upgrade package for additonal money:
    - Full set of Yukon 4340 shafts with spicer SPL55-3X ujoints
    - Yukon 35 spline locking hubs
    - Spartan locker

    I am willing to sell housing/knuckles for $500 with no gears/carrier and build up using other parts listed. I could cut the inner Cs and sell those plus knuckles for $450.

    I will entertain partial trades(no 420). Here are some specific items:
    - Rear axle from ~2000 Ford e350 van(dana 60 full float 8x6.5")
    - ~86 S10 steering column(tilt, manual trans)
    - Aftermarket wiring harness for a 2004 LQ4; drive by wire, manual trans.
    - Set of four or five 16"x8" 8x6.5" white spoke wheels (wagon wheels)
    - Two used 10" travel 2.5" body King coilovers
    - Two air bumps

    Click image for larger version
Name:	knuckles_sml.jpg
Views:	58
Size:	189.9 KB
ID:	160258 Click image for larger version
Name:	caliperBracket_sml.jpg
Views:	52
Size:	135.2 KB
ID:	160259 Click image for larger version
Name:	steerArm_sml.jpg
Views:	52
Size:	201.1 KB
ID:	160260 Click image for larger version
Name:	hubs_sml.jpg
Views:	50
Size:	262.2 KB
ID:	160261 Click image for larger version
Name:	axles_sml.jpg
Views:	56
Size:	289.1 KB
ID:	160262

    I've also got a set of 16 Dorman 610-563 that I can work into a sale. These are the "extra long" studs to make alloy wheels easier to use.