5 legged table missing hardware. ID help

Collapse
X
Collapse
First Prev Next Last
 
  • Filter
  • Time
  • Show
Clear All
new posts

    5 legged table missing hardware. ID help

    My wife inherited this 5 legged table from her grandmother. It looks to be complete other than it's missing a leaf and one of the clips that holds the leg in. The clip is what I'm after, but I have no idea what it would be called or where to start looking. Was hoping someone here might have some sort of insight. Thanks!

    #2
    That's a dickfer.

    Comment


      #3
      Originally posted by Ted_Kaczynski View Post
      That's a dickfer.
      What's...that...for...?

      Comment


        #4
        I don't know what it's called exactly. Some sort of corner block hanger retainer. Light googling didn't turn up anything useful for me. Are you opposed to using a large washer?

        Comment


          #5
          Does that go in the corner on the 45* piece for tension? If so a large, fat washer or two should work. You could drill 2 holes fro screws and zip out a slice for the shank to slide into.

          Check here https://www.rockler.com/shop?w=hanger+bolt

          Last edited by Pony_Driver; 05-27-2020, 06:22 AM.

          Comment


            #6
            Originally posted by Pony_Driver View Post
            Does that go in the corner on the 45* piece for tension? If so a large, fat washer or two should work. You could drill 2 holes fro screws and zip out a slice for the shank to slide into.

            Check here https://www.rockler.com/shop?w=hanger+bolt
            Thank you just what I needed some place else to spend my day at

            Comment


              #7
              Originally posted by Pony_Driver View Post
              Does that go in the corner on the 45* piece for tension? If so a large, fat washer or two should work. You could drill 2 holes fro screws and zip out a slice for the shank to slide into. But also looks like I could make one of those corner

              Check here https://www.rockler.com/shop?w=hanger+bolt
              Correct. The leg has the bolt screwed into it and then the bolt goes through the 45* piece and the two tabs lock it into place. The washer plan was going to be my back up if I couldn't find something like the original piece. But also looks like I could make those corner brackets work if it came down to it.

              Comment


                #8
                Or try van dykes. I'm sure they'd have it.

                https://www.vandykes.com/?gclid=Cj0K...kaAhNyEALw_wcB

                Comment

                Advertisement:
                Advertisement:
                Advertisement:
                Advertisement:
                Advertisement:
                Advertisement:
                Advertisement:
                Working...
                X