Anyone Make a D60 Hub with TT Pattern 6x6.5"

[TTMotorsports]

Curious for a possible future project does anyone make a Dana 60 and GM 14 bolt wheel hub that is a TT 6x6.5" Bolt Pattern? I got a set of TT wheels and tires and planning my next TTB build and will weld holes and machine factory hubs to bolt pattern BUT it would be easier to purchase some forged hubs that are 6x6.5" pattern OR BLANKS that I could simply drill the correct bolt pattern for my setup.

Thanks

 

[YotaAtieToo]

I want to say that 6x6.5 doesn't over lap 8x6.5

I thought about redrilling my axles to utilize cheap tt take offs

 

[total newb]

I thought spidertrax would offer some but i only see unit brg stuff.


Id think going straight to solid or dynatrac is gona be your best bet on blanks.

 

[TTMotorsports]

Yeah as long as the front and back of the hub is smooth I could just drill the 6 on 6.5 pattern and they don't overlap at all. I believe factory hubs have thicker scalloped area for the studs to push through.

 

[Bebop]

Randy Slawson from Bomber fab redrilled some Solid hubs to 6x6.5 without problems.

 

[TTMotorsports]

Copy. I emailed Solid Axle to see if they would sell some blank hubs that I could drill myself.

 

[YotaAtieToo]

Yeah as long as the front and back of the hub is smooth I could just drill the 6 on 6.5 pattern and they don't overlap at all. I believe factory hubs have thicker scalloped area for the studs to push through.

Thread in studs would probably be the best bet for stock type hubs.

Or get solids, like mentioned

 

[Bebop]

Copy. I emailed Solid Axle to see if they would sell some blank hubs that I could drill myself.

Would work with already drilled ones

 

[TTMotorsports]

Thread in studs would probably be the best bet for stock type hubs.

Or get solids, like mentioned

Yeah going to run 5/8" studs so not thread in

 

[YotaAtieToo]

Yeah going to run 5/8" studs so not thread in

If you don't want thread in, I get it. But 5/8" thread in studs would not be hard to get.